Digital Stepper Driver DV860H-C DVS 2-PHASE FULL DIGITAL STEPPING MOTOR DRIVE DV860C is a new type of stepper drive developed according to the market demand.It adopts the advanced 32-bit DSP chip which is special for motor controlling. DV860C can make a stepper motor run more smoothly and it is not easy to lose steps. Moreover, it can receive input signal pulses, direction signal and enable input signal. When internal position is used, the pulse and direction interface can be used for sensor signal input and accept 485 controlling. DV860C can make the motor create smallest heat and vibration, while the machining speed and precision of the mechanical operation are better improved. The drive voltage ranges from AC18V-80V/ DC25V-110V.It is designed for using with 2-phase hybrid stepper motors of all kinds with 57mm to 86mm outside diameter, regulated phase current under 6.0A. -- Features:  16 channels micro steps with equal angle and constant torque. Highest micro step: 51200ppr.  Highest response frequency: 200Kpps.  The coil current will be reduced by approximately 50% when SW4=OFF and no step pulse is received for 1.5 seconds.  Opto-isolated signal I/O.  Drive current is adjustable in 8 channels from 2.0A/phase to 6.0A/phase.  Single power supply from 18V-80VAC/25V-110VDC.  Better to overcome the problem of low frequency vibration  Dimension : 150×53×97.5mm3; Net Weight : 0.6Kg #DV860C-H #DVS Mechatronics #Stepper Motor in Vadodara #Stepper Driver in Vadodara